How do I modify the point sets of a parameter?

Geometry Elements - Parameters

To modify the point set of an anchored parameter, do the following:

1. Right-click on the parameter and select Modify Point Set from the pop-up menu which appears. All points in the point set are selected.

2. To add a point, hold down the control key and click on the point you wish to add to the point set. The point is highlighted indicating its addition to the point set.

3. To delete a point, hold down the control key and click on the highlighted point you wish to remove from the point set.

4. When you have the desired point set selected, hit the return key.

To modify the left point set of a symmetric parameter, right-click on the symmetric parameter and select Modify Left Point Set from the pop-up menu, then continue at step 2 above.

To modify the right point set of a symmetric parameter, right-click on the symmetric parameter and select Modify Right Point Set from the pop-up menu, then continue at step 2 above.

For more details about selecting and unselecting points in your geometry, see Editing Your Circuit.